PSRTTYPS Ham-ware / AKIHABARA-GIKEN Software list ↗

Screenshots and the PDF guide are in Japanese.

RADIO SETTINGS

Radios available in model selection

These models are available in Settings. Configure the radio and select COM, Audio IN and OUT to connect and operate.

Currently supports 66 models.

Blue cards indicate hardware-tested models.

Blue cards show previously reported hardware operation, not hardware verification of FSK. FSK notes describe connection requirements based on manufacturer documentation.

FSK keying transmission · Ver1.18

ICOM

ICOM / CI-V

Models with direct USB connection

Selecting a model fills its standard CI-V address; edit it if changed on your radio.

IC-7200/7410/7600 were added from documentation. Set filters on the radio for IC-7200/7410/7600/9100.

ICOM / CI-V CABLE

Models without direct USB connection

These radios do not connect directly by USB. Use a CI-V cable or interface and connect audio through suitable cables/interfaces too.

ICOM / CI-V + EXTERNAL PTT

Models also needing an external PTT interface

No direct USB connection. Frequency read/control uses a CI-V cable or interface; audio requires a separate connection.

PTT requires an external PTT interface in addition to CI-V.

OTHER ICOM

Other ICOM

Other ICOM allows manual CI-V address and other settings. It does not guarantee all model-specific controls or connection behavior.

Yaesu

YAESU / CAT

Models with direct USB connection

For USB models, match Enhanced COM, CAT speed and stop bits to the radio, and set DATA input to USB.

YAESU / USB CAT + EXTERNAL AUDIO

USB CAT control with a separate audio connection

FT-891 supports CAT control over USB but does not provide USB audio input/output. Connect audio separately through an external audio interface such as SCU-17.

YAESU / CAT CABLE or SCU-17

Models without direct USB connection

FT-817/FT-817ND, FT-818ND, FT-857/FT-857D, FT-950 and FT-450 do not connect directly to a PC via USB. Use a CAT-compatible cable or interface, with a separate connection for audio input/output.

External connections for Yaesu radios vary with the interface, cables and PTT method, including setups using SCU-17 or Digirig. “Verified on actual hardware” indicates confirmation with the reported setup. Configure CAT, audio input/output and PTT to match your setup.

Kenwood

KENWOOD / CAT

Model selection / connection

Experimental Hamlib support. Check model-specific connection and control settings.

Available controls depend on model, mode and readable state. Unsupported/unreadable operations are disabled. Start with Help → Initial Setup Guide for connection and model notes.

Initial setup steps →

Please report hardware test results

For models not yet hardware tested, please use the contact form to report your results.

If you are the first to report a previously untested model, you may request one base PCB for the RTTY printer free of charge.

If you have already reported and received our thanks, contact us to request one free base PCB.

Contact form →About the RTTY printer →