PSSAQPS HAM-WARE
Back to software list ↗

PSSAQ / GUIDE

Setup & use

Start by checking the audio path and selecting input and output devices.

  1. 17.2 kHz receiver
  2. PC recording input
  3. PSSAQ
  4. Speaker / headphones

  1. Connect the receiver output

    Connect AUDIO OUT from a receiver that provides the signal near 17.2 kHz to a PC or USB audio recording input. This is not an input for CW already converted to an audible tone by a conventional receiver.

  2. Choose Audio IN and OUT

    Open Settings → Audio IN / Audio OUT settings. Select devices, input channel and CW tone. Recording and processing use a fixed 48 kHz sample rate.

  3. Check sound and spectrum

    Use Output test to check the output device, then inspect the input level and FFT. Tune on the spectrum and compare bandwidth and NR settings by ear.

  4. Record and review

    Start recording with REC and end with STOP. File → Open recording reanalyses a compatible WAV. Treat decoded text as an estimate and compare it with the sound.

Contact

For operation reports or suggestions, include your version and connection setup.

Contact →