目次

Virtual Serial Ports Emulator for RS-BA and JTDX

VSPEを使い、USBシリアルポートをスプリットして、RS-BAとJTDXで使う。

同時に使おうとすると奪い合いになりカチカチしてエラーになる。上手く共有できないので、ここでは単純にリセットせずに使えるようにするための設定。

つまり、Icom Remote Utilityやイニシャライズ、再接続をSKIPさせて、それぞれの起動だけですぐに使えるようにする。

Using VSPE, split the USB serial port and use it with RS-BA and JTDX. If you try to use them at the same time, they will compete with each other and tick and error.Since they can't share well, here is a simple setup to use them without resetting. In other words, Icom Remote Utility, initialization, and reconnection are SKIPed so that they can be used immediately after each startup.

  

注意事項

VSPEのVer.は以下の通り(なお、最新β版ではうまくいかず)

また、無線機の電源を切り、暫くすると共有ポートが沈黙してしまうので、電源を切った際は、VSPEの共有ポートを停止させる。

再度使う時は、無線機を立ち上げて、VSPEポートを開始させる。

VSPE Ver. is as follows (note that the latest beta version does not work well) * Virtual Serial Ports Emulator (x64) 1.5.2.288 Also, the shared ports of VSPE are silenced when the radio is turned off and the shared ports are silenced after a while. When it is time to use it again, the radio should be started up and the VSPE port should be started.

  

JTDX 残タスクの処理

うっかりVSPEを起動せずにJTDXを起動したりすると、WindowsタスクにしばらくJTDXが残ってしまうことがある。これは、不正終了や何か未接続での終了しても起きること。

If you inadvertently start JTDX without starting VSPE, JTDX may remain in the Windows task for a while.This happens even if you exit unauthorizedly or exit with something unconnected.

タスクから強制削除.bat 例(for example.bat)

C:\Windows\System32\cmd.exe /C taskkill /IM jtdx.exe /f

  

設定画面

画面では、CATコントロールのポート5を2と3に共用としてわけている。